Filter
Top Products
Note
This function is provided with 1080 50i-compatible devices only. It is not provided with 1080
60i-compatible devices. The 1080 50i-compatible devices have a “50i” mark on the bottom of
the product.
If you insert a memory card that has previously been formatted with the PAL system, a
message telling you that you must re-format the card appears. When you record using the
NTSC system, re-format the memory card or use another memory card.
When the NTSC mode is selected, the “Running on NTSC.” message always appears on the
start-up screen each time you turn the product on.
[166] How to Use
Changing settings Setup menu
Cleaning Mode
Allows you to clean the image sensor.
1. MENU → (Setup) → [Cleaning Mode] → [Enter]
2. Turn off the product following the instructions on the screen.
3. Detach the lens.
4. Use the blower to clean the image sensor surface and the surrounding area.
5. Attach the lens.
Note
A blower is not supplied with this product. Use a commercially available blower.
Cleaning can be performed only when the battery level is (3 remaining battery icons)
or more. The use of an AC-PW20 AC Adaptor is recommended.
Do not use a spray type blower as it may scatter water droplets inside the camera body.
Do not put the tip of a blower into the cavity beyond the lens mount area, so that the tip of
the blower does not touch the image sensor.
Hold the camera slightly face downward so that the dust falls out.
Do not subject the product to any shock during cleaning.
When cleaning the image sensor with a blower, do not blow too hard. If you blow the sensor
too hard, the inside of the product may be damaged.
If the dust remains even after you cleaned the product as described, consult the service
facility.