Filter
Top Products
Saving and Loading Lens Files
164
Chapter 7 Saving and Loading User Setting Data
Use FILE >Lens (see page 153) in the setup menu
to set the data in lens files.
You can set the following data and save it as a
lens file.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
To save a lens file to an SxS memory card, insert
the card into a memory card slot and then proceed
as follows.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
1 Select FILE >Lens in the setup menu.
To assign a name to the data before saving
it
Assign a name before proceeding to step 2.
For details, see “To assign names to files”
(page 161).
2 Select Lens Store Mem >Execute (if you
want to save the data in the camcorder’s
internal memory), and select Lens Store
SxS >Execute (if you want to save the
data on an SxS memory card).
3 Press the MENU knob.
If you select [Execute], a list box of lens file
number appears. File numbers where “No
File” is displayed are empty file numbers.
4 Select the file number under which you
want to save the data, and then press the
MENU knob.
A confirmation message appears.
5 To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Lens Store SxS >Execute in
step 2, the ACCESS lamp lights (in blue on
the right-side panel and in orange in the card
slot section) when you execute the save.
When the data has been saved, a completion
message appears and the ACCESS lamp goes
out.
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page 73) to the external device connector.
Select Lens Store USB >Execute in step 2.
To load a lens file from an SxS memory card,
insert the SxS memory card into a memory card
slot, and then proceed as follows.
See “Basic Setup Menu Operations” (page 109) for
information about menu operations.
1 Select FILE >Lens in the setup menu.
2 Select Lens Recall Mem >Execute (if
you want to load the file from the
camcorder’s internal memory), and
select Lens Recall SxS >Execute (if you
want to load the file from an SxS
memory card).
3 Press the MENU knob.
If you select [Execute], a list box of lens files
appears. File numbers where “No File” is
displayed are empty file numbers.
Saving and Loading
Lens Files
Setting Lens File Data
Setting data Sub-items
V modulation shading
compensation values
M V Modulation
Center marker position Lens Center H
Lens Center V
Flare level Lens R Flare
Lens G Flare
Lens B Flare
White balance
compensation value
Lens W-R Offset
Lens W-B Offset
White shading
compensation value
L R/G/B H Saw
L R/G/B H Para
L R/G/B V Saw
L R/G/B V Para
Saving Lens Files
Loading Lens Files