Filter
Top Products
193
Viewing Images on Your Computer
Making the computer recognize the camcorder
Viewing images recorded on a “Memory Stick”
(1) Insert a “Memory Stick” into your camcorder.
(2) Connect the AC Adaptor and set the POWER switch to MEMORY.
(3) Connect the
(USB) jack on your camcorder to the USB connector on your
computer using the supplied USB cable.
“USB MODE” appears on the screen of your camcorder. Your computer
recognizes the camcorder, and the Add Hardware Wizard starts.
(4) Follow the on-screen messages so that the Add Hardware Wizard recognizes
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow
each installation to complete without interrupting them.
You cannot install the USB driver if a “Memory Stick” is not in your camcorder.
Be sure to insert a “Memory Stick” into your camcorder before installing the USB
driver.
USB connector
(USB) jack
USB cable (supplied)
Push into the end
Connecting your camcorder to your computer using the USB cable