Filter
Top Products
48
Playing back a tape
To not display various settings
Set DATA CODE to DATE in the menu settings (p. 222).
The display changes as follows when you press DATA CODE on the Remote
Commander:
date/time y no indicator
Notes on the data code
•The data code does not work with tapes recorded in the Hi8 /standard 8 mm
system.
•Various settings of the data code are not recorded when recording images on a
“Memory Stick.”
Data code (Various settings)
The data code is your camcorder’s information at the time of recording. In the recording
mode, the data code will not be displayed.
When you use data code, bars (-- -- --) appear if :
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to a TV, the data code appears on the TV screen.
Remaining battery time indicator during playback
The indicator indicates the approximate continuous playback time. The indicator may
not be correct, depending on the conditions in which you are playing back. When you
close the LCD panel and open it again, it takes about one minute for the correct
remaining battery time to be displayed.