Filter
Top Products
Chapter 4: BIOS
4-3
Wait for F1 if Error
This setting controls the system response when an error is detected during the
boot sequence. When enabled, BIOS will stop the boot sequence when an error
is detected, at which point you will need to press the F1 button to re-enter the
BIOS setup menu. The options are Enabled and Disabled.
Hit DEL Message Display
Enabling this setting displays the "Press Del to Run Setup" message in POST.
Options include Enabled and Disabled.
Watch Dog Mode
This setting allows you to set the system to restart when it is not active. Options
include Disabled, Enabled and More than 5-minutes.
Power Button Mode
This setting allows you to select the power button functionality. Options include
Instant Off and 4-seconds Override.
Restore on AC Power Loss
If the system loses power, this setting allows you to specify the state of the
system when power is restored. Options include Last State, Power On and
Power Off.
Interrupt 19 Capture
Select Enabled to allow ROMs to trap Interrupt 19. The options are Enabled
and Disabled.
Processor & Clock Options
CPU Information
This setting selects which physical CPU information to display.
Note: Zero is always the "Boot Strap Processor" or main CPU while all others
are "Application Processors".
GART Error Reporting
This setting is used to Enable or Disable GART error reporting.
Microcode Update
This setting is used to Enable or Disable microcode updating.