Filter
Top Products
25
6.2.1 General
¾ RTSP: The default value is 554. If the IP Cameras connected with router and installed outside
are over 2 sets and all of them need support RTSP, please fill some value in the blank space in
the range from 1024 to 65535.
¾ RTP Unicast streaming: The default value of port range is 5000 ~ 7999 and can be changed
from 1024 to 65535.
) Note:
Under Unicast streaming mode, streaming video is delivered from the Camera to a single client device.
¾ Image rotated: Select the screen display “None”, “Flip”, “Mirror”, or “Mirror + Flip.”
¾ Audio Codec: Select one audio codec among G.711 U-law / G.711 A-law / AMR Audio / Off.
z G.711 U-law: one codec for “Computer Audio”, used in North America & Japan areas.
z G.711 A-law: another codec for “Computer Audio”, used in Europe and the rest of the world.
z AMR Audio: an audio codec of the third generation communication for MOBIL
z Off: Select Off, audio file won’t be transmitted by IP CAM.
¾ Audio Mode: You can select Full duplex or Half duplex.
z Full duplex: Select it for simultaneous communication in both direction between the
connected administrator and IP CAM. It means both parties can speak and be heard at the
same time.
z Half duplex: Select it for communication in both directions, but only one direction at a time
(not simultaneously). It means one party begins receiving a signal, it must wait for the
transmitter to stop transmitting, before replying. Therefore, once one party speak, he can’t
hear any voice from the other party, just like the communication by radio set.
¾ Video Clip Format: Select RECORDING compression format H.264 or MPEG-4.
z MPEG-4: MPEG-4 has the advantage of sending a lower volume of date per time unit
across the network (bit-rate) compared to Motion JPEG and therefore provides a relatively
high image quality at a lower bit-rate (bandwidth usage).
z H.264: H.264 provides higher compression rate than MPEG-4. Thus, H.264 can decrease
the bandwidth usage and further apply on 3G. However, H.264 will occupy more system
resources than MPEG-4. As long as the operating system appears operating difficulties
under H.264 format, please change to select MPEG-4.
¾ LED Indicator: The status of the LED indicatiors on the Camera. It’s turne on by default.