Filter
Top Products
UVS-7111 User's Manual
System Settings
System setting contains basic and application settings. The basic setting is executed for basic
system information, transmission speed, audio/video code, user authorization, date/time, and IP
filter, while the application setting is executed for event triggering definition and other relevant
settings, denition of the motion detection area, rmware update, reset to factory default, and reboot.
Basic Settings
Click setting to enter
the setting apge
Basic Setting > System (System info)
◦ Basic Setting > System > System Info
Device Name: You can set the name for your camera here. Click Set to complete the setting.
MAC Address, IP Address, Network Mask, Gateway: Network information.
Firmware: Firmware version information.
Current Viewers: The number of viewers who are currently accessing the video stream.
◦ Basic Setting > System > System Log
The administrator can view all login information of this camera, including boot record, video
streaming mode, login IP, changes, and the date/time information. You can copy the entries to a
Word document and save them manually. Please note that all information is deleted when you
turn off the machine.
24
System Settings / Basic Settings
LED:
LED:
Event status: You can set the LED display mode (ON, OFF, Flash) here.
ON: The LED ashes when any motion detection or alert trigger is identied.
OFF: LED is turned off.
Flash:LED ashes according to the user-dened interval.
Link status: You can set the LED display mode (ON, OFF, Flash) here
ON:The LED lights up green when a video stream is detected. Otherwise,
it does not activated.
OFF:LED is turned off.
Flash:LED ashes according t o the user-dened interval.