Filter
Top Products
UVS-7111 User's Manual
Ex.: Wireless mode setting (applicable to most situations)
Selection:
1. Mode: Select Infrastructure to connect the camera to a wireless base station.
2. Authentication Type: Select Shared Key.
3. SSID: Enter the server name of the base station.
4. WEP Encryption: Select the encrypted key that is the same as the base station.
5. KEY: Select a group that is the same as the wireless base station. You must select KEY1 for base
stations that only have a set of keys.
6. DHCP ON/OFF: DHCP ON is recommended.
7. Save the settings.
8. Restart the rquipment.
◦ Basic Setting > Network > Wireless > Wireless IP Assignment
(IP setting in the wireless networking mode)
DHCP setting:
DHCP (Dynamic Host Configuration Protocol) is a protocol that enables automatic assignment
of TCP/IP information to the client. Each DHCP client connects to the DHCP server to access its
network setting information, including IP address, gateway, and DNS server.
The IP address of the camera is 192.168.0.20 by default when DHCP is “OFF”. When you select
“DHCP ON” and access to the DHCP network environment, the camera will automatically send a
DHCP packet request an IP address. This IP address is assigned automatically from the DHCP
server on the network. No additional settings are required for this page unless you need to change
the network conguration. The DHCP status of the camera is “OFF” by default.
Other settings:
For IP address, Subnet mask, Default gateway, DNS 1, and DNS 2, the DHCP server will assign
these values automatically when DHCP is in "ON" status; otherwise, you need to key in the values
manually.
41
Basic Setting