Filter
Top Products
UVS-7111 User's Manual
4. Click Browse… to select the location where the rmware le is stored.
5. Click submit.
6. The auto upgrade runs.
The Upgrade Status shows the progress of the upgrade.
When the firmware upgrade has been completed, the machine reboots automatically.
Reconnect to the server after 60 seconds.
Note:
The new firmware is burned into the Flash ROM during the upgrade, so you must take care
during the process and make sure it is not interrupted during the operation. The system may be
damaged seriously and need to be returned to the factory for repair if the power cable is removed
or becomes loose during the upgrade. Firmware upgrading in a wireless network environment is not
recommended because unstable packet transmission may bring about loss of data.
When the rmware upgrade has been completed, you don't need to restart the camera manually.
The camera will reboot automatically after 60 seconds (Reboot OK). Then open the IE browser and
key in the IP address (The original IP address remains undeleted).
58
Application Setting
Reset to factory default