Filter
Top Products
UVS-7111 User's Manual
Basic Setting > Network > PPPoE (dial-up networking setting)
PPPoE: Point-to-Point Protocol over Ethernet is a protocol that supports access to a high-speed
wideband network using a PC and a wideband modem (such as xDSL, Cable, Wireless modem).
The user need only to equip the PC with an Ethernet card and apply to ISP (such as HiNet) and
ADSL provider (such as Chunghwa Telecom) for ADSL service to roam the Internet through ordinary
twisted copper wires.
PPPoE: Point to Point Protocol over Ethernet is applicable to networking via a xDSL or cable
modem. PPPoE setting must be executed in the LAN environment for your PC to connect to ADSL.
Follow the steps below to complete the setting:
1. Dial: You can select whether or not to dial when you boot the machine.
2. Use DHCP or xed IP for connection to the LAN environment.
3. Key in the IP address of the camera and enter "PPPoE Setting" following the
route Setting → Basic Setting → Network → PPPoE.
4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click
Save to conrm the setting.
5. Where the ADSL modem and the camera is connected via a switch-hub, you
can press “Reboot” or restart the machine manually to try PPPoE dialing
when the setting of the camera has been completed.
6. To observe the new IP address acquired when PPPoE dialing has been
executed successfully, follow the route Setting → Basic Setting → Network
→ Notication for the IP information. You can acquire the new IP address
via SMTP, FTP, and HTTP. Refer to the “Notication Setting” page for more
information.
Note: You can use the DDNS function to access the camera. Refer to the “DDNS Setting” page for
more information.
◦ Basic Setting > Network > PPPoE > PPPoE
◦ Basic Setting > Network > PPPoE > PPPoE Information
43
Basic Setting
PPPoE setting
Dial:
Username:
Password:
You can select whether or not to dial when you boot the machine (On Boot or
Off).
Enter the username provided by your ISP.
Enter the password.
IP Address:
Subnet Mask:
Default Gateway:
DNS:
The IP address acquired when dialing has been executed successfully.
The subnet mask information acquired when dialing has been executed
successfully.
The gateway information acquired when dialing has been executed
successfully.
The ISP domain name acquired when dialing has been executed successfully.