Filter
Top Products
Network: PPPoE (dial-up networking setting)
PPPoE: Point-to-Point Protocol over Ethernet is a protocol that supports access to a
high-speed wideband network using a PC and a wideband modem (such as xDSL, Cable,
Wireless modem). The user need only to equip the PC with an Ethernet card and apply to
an ISP (such as HiNet) and an ADSL provider (such as Chunghwa Telecom) for ADSL
service to roam the Internet through ordinary twisted copper wires.
PPPoE: Point to Point Protocol over Ethernet is applicable to networking via a xDSL or
cable modem. PPPoE setting must be executed in the LAN environment for your PC to
connect to ADSL. Follow the steps below to complete the setting:
1. Dial: You can select whether or not to dial when you boot the machine.
2. Use DHCP or fixed IP for connection to the LAN environment.
3. Key in the IP address of the camera and enter "PPPoE Setting" following the route
Setting Basic Setting Network PPPoE.
4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click Save to
confirm the setting.
5. Where the ADSL modem and the camera is connected via a switch-hub, you can
press “Reboot” or restart the machine manually to try PPPoE dialing when the setting
of the camera has been completed.
6. To observe the new IP address acquired when PPPoE dialing has been executed
successfully, follow the route Setting Basic Setting NetworkNotification for the
IP information. You can acquire the new IP address via SMTP, FTP, and HTTP. Refer
to the “Notification Setting” page for more information.
Note: You can use the DDNS function to access the camera. Refer to the “DDNS Setting” page
for more information.
©2007 Asante Networks Inc., All rights reserved. NetCam are registered trademarks of Asante Network, Inc.
All other names may be trademarks or registered trademarks of their respective owners. Specifications subject to change without prior notice.
43