Filter
Top Products
45
AXIS 213 - System Options
LED Settings
When the LED on the front of the AXIS 213 is Enabled, the LED will remain lit when
the AXIS 213 is on and flash when there is any network activity. If Disabled, the LED
will remain off, except when there is a hardware problem and the LED will flash red.
Maintenance
• Restart - The unit is restarted without changing any of the settings. Use this
method if the unit is not behaving as expected.
• Restore - The unit is restarted and most current settings are reset to factory default
values. The settings that will not be reset are as follows:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
Default - The Factory default button should be used with caution. Pressing this button
will reset all of the AXIS 213's settings to the factory default values (including the IP
address)
Upgrade Server - See Updating the Firmware, on page 50.
Backup - click the Backup button to take a backup of all of the parameters, and any
user-defined scripts. If necessary, it is then possible to return to the previous settings
if the settings are changed and there is unexpected behavior.
Note: The root password will also be reset to the password saved in the backup file.
Restore - click the Browse button to locate the saved backup file (see above) and then
click the Restore button. The settings will be restored to the previous configuration.
Note: Backup and Restore can only be used on the same unit running the same firmware. This feature is
not intended for multi-configurations or for firmware upgrades.