Filter
Top Products
20 en | Installing a Surface Mount VEZ-400 Mini PTZ Dome
F.01U.252.635 | 2.0 | 2011.09 User Manual Bosch Security Systems, Inc.
1. Determine a secure location that can support the weight of
the dome.
2. Use the template (refer to Figure 6.1, item 1) to mark the
locations of the four screw holes and the cable conduit.
3. Pre-drill the four screw holes wide enough to accept the
plastic anchors.
4. Cut out the entire cable conduit hole.
5. Insert the four plastic anchors (item 2) inside the pre-
drilled holes.
6. Route the cables from the camera through the conduit in
the ceiling.
7. Remove the dome cover (item 6) from the camera base
(item 3).
8. Remove the white foam ring from the camera base, and
remove the white foam sheet from the inside of the dome
cover. (These are for protection during transport.)
9. Align the four screw holes on the camera base (item 3)
with the four plastic anchors.
10. Attach the camera base to the ceiling using the four #8 x
32 screws (with O-rings attached) (item 4). Tighten the
CAUTION!
To prevent humidity problems, the camera must be installed in
dry conditions, and the cable leads should be sealed after they
are connected.
NOTICE!
To prevent scratches on the dome cover, Do Not Remove the
plastic film protecting the dome cover until after hardware
installation is complete.
CAUTION!
When (re)mounting the camera base, make sure that each
mounting screw has a rubber O-ring. This ensures protection
against water ingress.