Filter
Top Products
VEZ-400 Mini PTZ Dome Installing a Surface Mount | en 21
Bosch Security Systems, Inc. User Manual F.01U.252.635 | 2.0 | 2011.09
screws enough to ensure that the camera base is secured
to the ceiling.
11. Make the necessary Dip Switch settings (described in
chapter 4.3). Note: This step can also be done later, but
then the dome cover must be re-opened.
12. Align the screw holes on the dome cover (item 6) with the
camera base.
13. Attach the dome cover to the camera base using the four
M4 x 12 Torx screws (with O-rings (item 4) attached) using
the supplied Torx wrench. Make sure that the large rubber
O-ring between the camera base and dome cover is in
place to protect the camera against water ingress. Tighten
the screws enough to ensure that the housing is secured to
the camera base and that the rubber O-rings seal the dome
cover against water ingress.
14. Remove the plastic film protecting the dome cover from
scratches.
CAUTION!
When (re)mounting the dome cover to the camera base, make
sure that each screw has a rubber O-ring, and that the large
rubber O-ring is in place on the camera base. This ensures
protection against water ingress.