Filter
Top Products
23Routine Maintenance
4 Start Print Head Cleaning.
(1) Click the Maintenance tab.
(2) Click Cleaning.
Print Head Cleaning starts when the Power lamp starts flashing green.
Do not perform any other operations until Print Head Cleaning finishes. This takes about
60 seconds.
(3) Load a sheet of A4 or Letter-sized plain paper in the Rear Tray.
(4) Confirm the displayed message and click Print Check Pattern.
The nozzle check pattern is printed.
Do not perform any other operations until the nozzle check pattern finishes printing.
5 Check the print head condition with the printed nozzle check pattern, and take
appropriate action.
See “Examining the Nozzle Check Pattern” on page 21.
Note
The nozzle check pattern will not be printed correctly if there is not enough ink. Replace the FINE
Cartridge if the remaining amount of ink is insufficient. See “Replacing a FINE Cartridge” on
page 31.
Note
If the problem is not resolved after performing steps 4 and 5 twice, try Print Head Deep Cleaning.
See “Print Head Deep Cleaning” on page 25.