Filter
Top Products
47D-Link DCS-5605/5635 User Manual
Section 3 - Configuration
To set up your IP camera’s wireless network
interface settings, enable Wireless Settings
in this window rst. Then continue the further
conguration next.
Clicking this button will scan for available
wireless networks. After scanning, you can use
the drop-down box to select an available wireless
network, and related information (SSID, Wireless
Mode, Channel, Authentication, Encryption) will
be automatically lled in for you.
Enter the SSID of the wireless access point you
wish to use.
Use the drop-down box to select the mode of the wireless network you wish to connect to. Infrastructure is
normally used to connect to an access point or router. Ad-Hoc is usually used to connect directly to another
computer.
If you are using Ad Hoc mode, select the channel of the wireless network you wish to connect to, or select .
Select the authentication you use on your wireless network - Open, Shared(WEP), WPA-PSK, or WPA-PSK2.
If you use WPA-PSK or WPA-PSK2 authentication, you will need to specify whether your wireless network
uses TKIP or AES encryption. If you use Open or Shared authentication, this setting will be automatically set
for you.
If you use WEP, WPA-PSK, or WPA-PSK2 authentication, enter the Key (also known as password) used for
your wireless network.
After making any changes, click the button to save your changes, or click the
button to discard your changes.
Wireless Setup (DCS-5635 only)
Enable Wireless:
Site Survey:
SSID:
Wireless Mode:
Channel:
Authentication:
Encryption:
Key: