Filter
Top Products
3-6
NOTICES
Note the following when preparing the paper.
• Remove paper clips and staples. Flatten the staple holes.
• Read the following documents using the Flatbed:
- Paper with clips or staples.
- Paper written on with wet ink.
- Paper of uneven thickness (for example, envelopes).
- Paper with large rumples or curls.
- Paper with folds or tears.
- Tracing paper.
- Coated paper.
- Carbon paper.
- Paper shorter than A8 (portrait) size or wider than A3 size or 11 x 17 inches.
- Materials other than paper (for example, clothes, sheet metal, or OHP film).
- Photographic paper.
- Paper with perforations on the side.
- Non-rectangular paper.
- Very thin paper.
• Set documents on the ADF so that the curl of the leading edge does not exceed the measures shown
below.
• To avoid skewing, do not feed docments of different widths during the same batch.
3
Adjust the stacker extension to the
paper size, and then flip out the plate.
Less than
5mm
More than 30mm
Top of the paper
Less than
3mm
More than 30mm
Feed direction
Top of the paper Read surface
Feed direction
Read surface
ADF paper chute
Stacker