Filter
Top Products
7-11
12. Low Power Mode Setting
<Screen 52>
1 Press “Next” or “Previous” and let the
scanner display Screen 52.
2 At Screen 52, press or to select the
time duration. A minimum of 5 min to the
maximum of 60 minutes can be selected.
Then press to activate the setting.
NOTICE
At screen 52, “No” does not mean that you can turn off the “Low Power Mode” (Power Save Mode). You
cannot disable the Power Save Mode.
NOTICE
The default time recommended by the ENERGYSTAR
®
program is 15 minutes. The default for the fi-4640S
scanner is 15 minutes, as recommended.
3 Press to return.
13. Select Interface
<Screen 53>
1 Press “Next” or “Previous” and let the
scanner display Screen 53.
NOTICE
The screen 53 will appear oniy when the scanner has proper interface boards or option boards in the third
party slot.
2 At Screen 53, press or to select the
interface type. Press if you want to
change the setting.
NOTICES
1. Normally, this setting does not have to be changed.
2. When an appropriate board is installed in the third party slot of the scanner, the scanner automatically
turns off the SCSI interface, activating the board in the third party slot. Screen 53 can be used to
forcibly change the selected interface. The selected interface is then forcibly changed.
3. The SCSI interface and the board installed in the third party slot cannot be used at the same time.
4. The default is Auto.
3 Press to return.