Filter
Top Products
Appendix
Chapter 1 Scanner Overview
Glossary
Introduction
Index
Contents
TOP
31
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Troubleshooting
Operational
Settings
Replacing the
Consumables
Scanner
Overview
Power saving mode keeps the power consumption low when
the scanner has not been used for a certain period of time.
If the scanner is left powered on for 15 minutes without being
used, it automatically enters power saving mode.
When it enters power saving mode, the Function Number
Display switches off but the [Power] button remains lit in
green.
To resume from power saving mode, perform one of the
following:
z Load a document in the ADF paper chute
z Press any button on the operator panel
Note that pressing the [Power] button for more than 2 seconds will
turn the power off.
z Perform scanning from an application
1.8 Power Saving Mode
The scanner may not enter power saving mode if there was a
document remaining on the paper path.
For details about how to remove documents, refer to "8.1
Paper Jam" (page 125).
The waiting time for entering power saving mode can be
changed in the Software Operation Panel.
For details, refer to "Waiting Time to Enter Power Saving Mode
[Power saving]" (page 187).