Filter
Top Products
AUTOMATIC DATE RECORDING
8. After setting AM or PM, press "DATE/TIME" button to change the display and start
the internal clock. It is recommended that you press "DATE/TIME" button to match the
time signal.
9. Press "DATE/TIME" button after setting the clock. The display will change as follows
each time the button is pressed.
t
4
13m&_
R_oves _spl_y
[NOTE:The date/time graphics will be recorded whenever they appear in the viewfinder. 1
1. Press and hold "DATE/TIME" button, and then press "STOP/EJECT" button. The
month starts flashing.
2. Correct the incorrect digit by using "F.FWD", "REW" and "STOP" buttons.
Press "STOP/EJECT" button repeatedly until the digit that is incorrect flashes. Correct
the incorrect digit by using "F.FWD", "REW" and "STOP/EJECT" buttons.
This feature records the date automatically once a day. After you begin recording, the
date is recorded automatically for 10 seconds. The same date is recorded again in the
following cases.
When the cassette is replaced.
When "® _o,, is displayed again after being switched to the date display.
When the recording is for less than 10 seconds.
26