JVC GY-DV300 Camcorder User Manual


 
E-27
VTR playback mode/IEEE1394 recording mode status indications
VOL.
DV
PLAY
q w
e
r
t
No. Item Contents
1 Audio playback volume Displayed in the VTR mode. Characters indicate the high and low of
indication the playback volume.
2 Time code indication The recorded time code data (hours, minutes, seconds, frames) are
shown here in the playback mode.
The indication is turned ON/OFF by setting the TIME CODE item on the
DISPLAY [2/2] menu screen.
3 Recording/playback The mode in which the tape was recorded is displayed during playback.
speed mode indication SP: Standard Play mode
LP: Long Play mode
When the remaining tape time indication is set to OFF, this indication is
shown at the position indicated by 4.
4 Remaining tape time Indicates the remaining tape time in 1-minute steps.
indication The indication is turned ON/OFF by setting the TAPE REMAIN item on
the DISPLAY [2/2] menu screen.
* The indication may not appear when a new tape is loaded, after the
tape runs, the indication appears.
5 Remaining battery The remaining battery power is indicated by four different indicators.
power indication
Blinking indicator
(no remaining
battery power)
Fully charged
battery