Filter
Top Products
E-84
EXTERNAL COMPONENTS
Connecting a Video Component
with DV Connector
1.
Connect the units with the DV cable.
2.
Turn ON both units.
3.
Set the MODE switch on the GY-DV300 to “VTR”.
4.
Insert the videocassettes.
GY-DV300: Insert the recorded videocassette.
Recording unit: Insert the videocassette to be dubbed to.
5.
Press the BAR button on the GY-DV300 to start playback.
6.
Start recording on the recording unit.
For details, see the instructions to the unit used for recording.
7.
When dubbing is completed.
Stop recording on the recording unit, and then press the AW
button on the GY-DV300 to stop playback.
When using the GY-DV300 as playback unit (dubbing to another videocassette)
Connecting the GY-DV300 to another video component equipped with DV I/O connector (IEEE1394
standard) using a DV cable (optional) enables dubbing of digital signals with high picture quality and
high-quality sound.
When used in a cold environment, this becomes 3 minutes regardless of the setting.
● Pressing the BAR button during
playback engages the still
mode.
● When a still picture is dubbed,
the dubbed picture will be
coarse.
● When the BR-DV600EA’s TC
DUPLICATE mode is used, the
time code data played back on
the GY-DV300 can also be
dubbed.
Memo:
● The operation methods differ with the characteristics and specifications of the connected equipment.
Even if connection is possible, operation or data communication may sometimes be impossible to
perform.
● When a D-9 (digital S) component is connected by means of IEEE1394, date and time data is not
recorded on the D-9 component.
● If noise appears on the screen or the sound drops out, disconnect the DV cable and then connect it
again or turn off the GY-DV300 before turning it on again.
MODE
CAM-B
VTRCAM-A
BAR
AW
BAR
button
AW button
MODE
switch
REC START/STOP button
DV connector
DV cable: VX-DV130 (4P-4P)
VX-DV230 (4P-4P)
DV connector
Memo:
The GY-DV300 cannot be used as the recording component.