JVC GY-DV300 Camcorder User Manual


 
E-45
Presetting the Time Code
Time code data should be set in the built-in time code generator. Users bits cannot be set. During
recording, the time code is automatically recorded on the tape.
When recording starts from the beginning of the tape, recording starts from the set time code.
SHUTTER
MENU
GAIN
SELECT
dial
TC PRE
S
CLOCK TC/
ET..
CLOCK
A
DJUST. .
TIME S
T
YLE
2
UR4HO
SE
C
DI
S
PLAY
O
N
DATE S
T
YLE
M
D/YYM/D
PAGE B
A
CK
TC
TC
PRESET
00
::
0
0
00
:
0
0
L
EARC
P
A
GE B
A
CK
C
ELANC
TC
TC
PRESET
00
::
0
0
00
:
0
0
L
EARC
P
A
GE B
A
CK
C
ELANC
CLOCK/TC menu screen
TC PRESET screen
Hours Minutes Seconds Frames
The time code is preset on the CLOCK/TC menu screen.
1.
Display the CLOCK/TC menu screen.
To display the CLOCK/TC menu screen, perform the operations
described in steps 1 to 3 in Setting the Date and Time on page
41.
2.
Rotate the SELECT dial to align the cursor (f) with the TC
PRESET item, and then press the SELECT dial.
The TC PRESET screen appears.
3.
Set the time code (hours, minutes, seconds, frames).
The blinking digit is the one to be set.
1 When the SELECT dial is pressed, the blinking digit changes.
2 When the SELECT dial is rotated, the value of the blinking
digit changes.
When the SELECT dial is rotated upward, the value becomes
higher. When rotated downward, the value becomes smaller.
3 Repeat the procedure described in 1 and 2 above to set
the desired value for all digits.
4 The setting values are confirmed and entered when the frame
digit blinks and the SELECT dial is pressed.
4.
When setting of all the digits is completed, rotate the SELECT
dial to align the cursor with the PAGE BACK item, and then
press the SELECT dial.
The CLOCK/TC menu screen returns.
MENU
button
PREPARATIONS FOR OPERATION
Setting, Displaying and
Recording the Time Code