Filter
Top Products
10
EN
GETTING STARTED
(cont.)
PAUSE
3
1
2
Grip Adjustment
1 Separate the Velcro strip.
2 Pass your right hand through the loop and grasp
the grip.
3 Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Viewfinder Adjustment
1 Set the Power Switch to “ ” or “ ” while
pressing down the Lock Button located on the switch.
2 Pull out the viewfinder fully and adjust it manually
for best viewability.
3 Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused.
Diopter
Adjustment
Control
Power Switch
Shoulder Strap Attachment
1 Following the illustration, thread the strap through
the eyelet 1, then fold it back and thread it through
the buckle 2. Repeat the procedure to attach the
other end of the strap to the other eyelet 3 located
under the Grip Strap . Confirm the strap is not
twisted.
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilize the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.
1 To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs.
Power Zoom Lever
Recording
Start/Stop button
Lock Button