Filter
Top Products
EN
25
Rewind Button (
2
)
Fast-Forward Button (
3
)
Play/Pause Button (
4
/6)
Stop Button (5)
Power Zoom Lever
(VOLUME)
Speaker
Still Playback:
Pauses during playback.
1) Press
4
/6 during playback.
2) To resume normal playback, press
4
/6 again.
●If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically
engaged. After 5 minutes in the Stop mode, the camcorder’s power is automatically turned off.
●When
4
/6 is pressed, the image may not pause immediately while the camcorder stabilizes the still image.
Shuttle Search:
Allows high-speed search in either direction.
1) Press
3
for forward or
2
for reverse search during playback.
2) To resume normal playback, press
4
/6.
●During playback, press and hold
2
or
3
. The search continues as long as you hold the button. Once you
release it, normal playback resumes.
●A slight mosaic effect appears on screen during Shuttle Search. This is not a malfunction.
Frame-By-Frame Playback: Allows frame-by-frame search.
1) Engage Still Playback.
2) Rotate the MENU wheel towards “▲” for forward Frame-By-Frame Playback, or towards “▼” for reverse
Frame-By-Frame Playback during Still Playback.
●To resume normal playback, press
4
/6.
●You can also use the provided remote control for Frame-By-Frame Playback (੬ pg. 64).
Slow-Motion Playback, Playback Zoom and Playback Special Effects
Available only with the remote control (provided) (੬ pg. 64, 65).
BASIC PLAYBACK
Playback From Tape
1 Load a tape (੬ pg. 12).
2 Set the VIDEO/MEMORY Switch to “VIDEO”, then
set the Power Switch to “ ” while pressing down
the Lock Button located on the switch. To start
playback, press
4
/6.
• To stop playback, press 5.
• Press
2
to rewind, or
3
to fast-forward the tape
during Stop mode.
To Control The Speaker Volume . . .
.....slide the Power Zoom Lever (VOLUME) towards
“+” to turn up the volume, or towards “–” to turn
down the volume.
VIDEO/MEMORY
Switch (Open the
LCD monitor to
access this switch)
NOTES:
● If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To
turn on again, set the Power Switch to “OFF”, then to “
”.
● The playback picture can be viewed in the LCD monitor, viewfinder or on a connected TV (
੬ pg. 54).
● You can also view the playback picture on the LCD monitor with it flipped over and pushed against the camera body.
● LCD monitor/viewfinder indications:
• When power is supplied from a battery: the “
” battery pack remaining power indicator is displayed.
When power is supplied through the DC cord: “
” does not appear.
• During Stop mode, none of the indications are displayed.
● When a cable is connected to the AV or PHONE connector, the sound is not heard from the speaker.
ATTENTION
During Shuttle Search, parts of the picture may not be clearly visible, particularly on
the left side of the screen.