1-2 April 28, 2004
Important Information
Warnings
Safety Warnings • To prevent fire or shock hazard, use only the recommended accessories
and attachments.
Operational Warnings • Do not use IEEE 1394 repeaters when connecting your camera. Doing
so can damage the camera.
• Be sure the connector orientation is correct when you connect the IEEE
1394 cable to the computer. Connecting incorrectly can damage your
camera or computer. At the computer connection, the point on the 6-pin
plug must align with the point on the computer port.
• Use extreme care when handling memory cards as they are easily
damaged. If a card is dropped, all data on the card can be lost.
• Do not remove a memory card, the KODAK PROFESSIONAL DCS Pro
Battery, or the KODAK PROFESSIONAL DCS Pro DC Power Module from
the camera while the memory card icon on the Digital Status LCD or the
Card Busy LED are blinking. The blinking indicates that data is being
read from or written to the card. You may lose data if you remove a card
at this time.
• Operate your camera only from the type of power source indicated on
the name plate of the KODAK PROFESSIONAL DCS Pro DC Power
Module. A line voltage outside this range can destroy the power module
and/or the camera.
• Use only the KODAK PROFESSIONAL DCS Pro DC Power Module included
with your camera or available from Kodak as an accessory. Do not plug
other adapters into the camera.
• The KODAK PROFESSIONAL DCS Pro DC Power Module is for indoor use
only.
• Do not use the supplied KODAK PROFESSIONAL DCS Pro DC Power
Module for any purpose other than for the KODAK PROFESSIONAL DCS
Pro SLR/c Digital Camera.
• Use the Image LCD to verify that a picture was captured correctly during
your photo session.
• Do not attempt to replace the Focus screen. Return the camera to an
authorized KODAK service center if the focus screen needs replacing.