Filter
Top Products
5-2 April 28, 2004
Configuring your Camera
Setting Battery Save
You can set separate battery save times for the camera and the Image LCD.
Camera To conserve battery power, your camera goes into a low-power mode if not
used for a specified amount of time.
1. Choose Battery Save from the Tools menu, choose Camera, then
highlight the desired time-out.
2. Press the OK button.
NOTE: When the Camera Battery Save time elapses, both the Image LCD
and the Top Status LCD turn off. To exit the Battery Save state, turn
the D-Dial to OFF, then turn it to Single Frame shooting.
Alternatively, lightly press the Shutter Release button.
NOTE: If the camera has an IEEE 1384 connection to a computer that is
turned on, the camera never enters the Battery Save state. As long
as the IEEE 1394 connection remains, the camera stays "awake",
checking to see if the DCS Camera Manager software is running on
the computer.
Image LCD
1. Choose Battery Save from the Tools menu, choose Display, then
highlight the desired time-out.
2. Press the OK button.
The Image LCD turns off when the Display Battery Save time elapses.