Filter
Top Products
2200
Getting up and running
2211
CHARGING THE BATTERY
Before the camera can be used, the lithium-ion battery must be charged. Before charging the
battery, read the safety warnings on page 4 of this manual. Only recharge the battery with the
supplied battery charger. The battery should be recharged before each shooting session. See page
142 for battery care and storage.
With the battery contacts toward the charger, align the channels
on the bottom of the battery with the tabs on the charger unit.
Slide the battery into the unit.
Plug the power cord into the back of the charger unit (1). Plug
the other end of the cord into a live household outlet. The
included AC cord is designed for the current of the sales region.
Only use the cord in the region it was purchased. For more on
the AC cable, see page 114.
Slide and lift the battery to remove it from
the charger. Unplug the power cord
from the outlet.
The indicator lamp (2) glows to show the battery is charging. The
lamp goes out when the battery is charged. Charging time is
approximately 150 minutes.
The EVF has a built-in diopter that can be
adjusted between –3.0 to +1.0. While looking
through the EVF, turn the diopter-adjustment dial
until the viewfinder focus frame is sharp.
DIOPTER ADJUSTMENT
Install the monitor protection panel by placing
the top of the panel at the top of the monitor
frame on the camera and lower panel until it
clicks into place at the bottom.
INSTALLING THE MONITOR PROTECTION PANEL
To remove the panel, lift from the bottom.