Filter
Top Products
DISCONNECTING THE CAMERA FROM THE COMPUTER
112288
112299
Data-transfer mode
Windows Me, 2000 Professional, and XP
Confirm that the access lamp is not lit. Turn off the camera and then disconnect the USB cable.
Never disconnect the camera when the access lamp is lit - the data or
memory card may permanently be damaged.
To disconnect the camera, click once on the unplug-or-eject-hardware icon located
on the task bar. A small window opens indicating the device to be stopped.
The hardware devices to be stopped are displayed.
Highlight the device by clicking on it then click
“Stop.”
Confirm that the access lamp is not lit and then drag the
mass-storage device icon and drop it into the trash.
Disconnect the USB cable.
Windows 98 / 98 Second Edition
A confirmation screen appears to indicate
the devices to be stopped. Clicking “OK”
stops the device.
A third and final screen appears to
indicate the camera can be safely
disconnected from the computer; click
OK. Turn off the camera and then
disconnect the USB cable.
Macintosh
When more than one external device are connected to the computer, repeat the procedure above
except right click on the unplug-or-eject-hardware icon. This opens the unplug-or-eject-hardware
window after clicking on the small window indicating the unplug-or-eject-hardware routine.
Click on the small window to stop the
device. The safe-to-remove-hardware
window will open. Turn off the camera
and then disconnect the USB cable.