Filter
Top Products
113333
113322
Data-transfer mode
PICTBRIDGE
Use the left/right keys of the controller to display the
image to be printed.
Total number of prints
Number of copies
Press the up key to select the number of copies to be
printed. To deselect an image for printing, press the
down key until the number of copies reaches zero. A
maximum number of fifty images can be printed.
Repeat the previous steps until all the images to be
printed are selected. Press the central button of the
controller to continue.
The number of prints in the print run are displayed as well as the
print parameters selected with the menu. See the menu navigation
section for more information (p. 134). Press the central button of
the controller to begin printing, or press the menu button to return
to the PictBridge screen.
Once printing begins, the operation can be canceled by pressing
the center of the controller. The printing-finished message
indicates the end of the operation; turn the camera off to end the
routine.
The display button switches between the single frame and index playback formats on the
PictBridge screen. Enlarged playback, activated with the magnification button (p. 38), can be used
to examine image files on the screen.
If the battery is exhausted before the print run is complete, printing is canceled. Use a fully-charged
battery or the optional AC adapter.
If a minor problem occurs during printing, such as the paper runs out, follow the procedure
recommended for the printer; no action is required for the camera. If a major printer error occurs,
press the center of the controller to end the routine. Refer to the printer manual for the correct
procedure for the printer problem. Check the printer settings before starting again and deselect the
images that were printed.
NOTES ON PRINTING ERRORS
PPrriinnttiinngg ffiinniisshheedd..
OOKK
Confirm the transfer-mode option in section 1 of the setup menu is
set to PTP. Connect the camera to a PictBridge compatible printer
using the camera’s USB cable. The larger plug on the cable is
connected to the printer. Slide open the video out / USB port
cover and insert the smaller plug of the cable into the camera. Turn
the camera on; the PictBridge screen is displayed automatically.
NNoo.. ooff pprriinnttss:: 55
PPrriinntt ssiizzee:: PPrriinntteerr sseettuupp
LLaayyoouutt:: PPrriinntteerr sseettuupp
PPrriinntt qquuaalliittyy:: PPrriinntteerr sseettuupp
DDaattaa pprriinnt
t:: PPrriinntteerr sseettuupp
::ssttaarrtt
Individual still images can be selected for printing on the PictBridge screen; RAW and images with
the embedded Adobe RGB color profile (p. 68) are not displayed and cannot be selected. For other
printing options, see the menu navigation section on page 134.
PictBridge screen
::mmoovvee ::sseelleecctt ::pprriinntt