Filter
Top Products
19
Leica SP 2600 Ultramilling attachment
5.1 Overview of chapter 5 Operation
Prior to working with the Leica SP2600 ultramilling attachment, be
sure to read the following instruction manuals:
The entire Leica SM2500 instruction manual except chapters
5.5.6 through 5.7.
This supplementary instruction manual Leica SP2600.
Chapter 5 of this supplementary instruction manual Leica SP2600 includes
the following subchapters:
5.1 Overview - chapter 5.
5.2 Adjusting the pre-millers in the calibrating device
5.3 Adjusting the finishing millers in the calibrating device
5.4 Specimen holder systems - how to combine individual components
5.5 Clamping specimens
5.5.1 Installing the base plates in the basic instrument
5.5.2 Clamping the specimen holders in the base plate with dovetail guide
5.5.3 Clamping the vacuum stages on/in the base plates
5.5.4 Connecting the vacuum pump/placing specimens onto the vacuum
stages
5.6 Preparatory steps prior to the milling procedure
5.7 Pre-milling
5.7.1 Perspective view of the pre-milling procedure
5.8 Finishing milling
5.8.1 Perspective view of the finishing milling procedure
5.9 Switching the instrument off (switching off the control unit).
Initial operation:
The first time you operate the instrument, we recommend you work through
the above subchapters, in numerical order as listed.
Pay particular attention to the safety instructions..
5. Operation