Filter
Top Products
33
Leica SP2600 Ultramilling attachment
Placing specimens onto vacuum stage for 30 -
50-mm lids
Fasten a lid suited to the size of the specimen
to be milled onto the vacuum stage (slotted
screws are part of standard delivery of
vacuum stage lids - use slotted screwdriver).
Place the specimen (1) onto the sintered sur-
face (2) of the lid.
Switch on the vacuum pump.
Placing specimens onto vacuum stages for per-
forated specimen holders
Fasten a perforated specimen holder (3) suited
to the size of the specimen on the vacuum
stage 76 x 25 mm (4) or onto the vacuum stage
with variable surface (not shown here).
Place specimen on the perforated area of the
vacuum stage
Switch on the vacuum pump.
The following is recommended for all
vacuum stages, no matter of which
type and size:
If the specimen is smaller than the sin-
tered or perforated stage surface, the
entire stage surface not covered by the
specimen should be covered with
autoadhesive plastic film.
Placing specimens onto vacuum stage 55 x 100
mm
Place the specimen directly on the sintered
surface area of the vacuum stage.
(Vacuum stage 55 x 100 mm not shown here).
5. Operation
Fig. 5.19 12
Fig. 5.20 3
Fig. 5.21 4