7
Leica SP 2600 Ultramilling attachment
1. Important information
1.3 Information on this instruction manual
Instrument type
This supplementary instruction manual must be used together with the Leica
SM2500 sliding microtome instruction manual describing the basic instru-
ment Leica SM2500, which is needed to operate the Leica SP2600 ultramill-
ing attachment.
All information provided in this supplementary instruction manual applies
only to the instrument type indicated on the title page.
A name plate indicating the instrument type and serial number is attached to
the rear of the Leica SP2600 ultramilling device.
Working with this instruction manual
This supplementary instruction manual contains important instructions and
information related to the operating safety and maintenance of the Leica
SP2600 ultramilling attachment.
It is an important part of the Leica SP2600 ultramilling attachment.
Prior to setting up and operating the Leica SP2600 together with the Leica
SM2500 be sure to read carefully both this supplementary instruction
manual as well as the Leica SM2500 instruction manual, with the exception
of chapters 5.5.6 - 5.7 of the Leica SM2500 manual. These chapters describe
installation of knife holders / knives and sectioning with the Leica SM2500
and are not of importance for operating the Leica SP2600 ultramilling attach-
ment.
If additional requirements on accident prevention and environmen-
tal protection exist in the country of operation, this supplementary
instruction manual must be supplemented by additional appropri-
ate instructions to ensure compliance with such requirements.
Fig. 1.2