Filter
Top Products
25
Leica SP2600 Ultramilling attachment
5.3 Adjusting the finishing millers in the
calibrating device
Carry out preparatory steps as per chapter 5.2,
page 20 (Adjusting the pre-millers in the cali-
brating device).
Twisted or deformed springs for the
miller holders must be exchanged!
Insert spring and finishing miller as described
in chapter 5.2, page 20 (Inserting the miller into
the miller holder).
When the finishing miller is inserted
into the holder, the letter F must be
visible. - That way, the milling edge is
pointing into the right direction.
Fig. 5.10
5. Operation