Filter
Top Products
VPort 2310 User’s Manual Introduction
1-7
Reset Button
A recessed RESET button is provided for restoring the system to the factory default settings.
When the system fails to install properly, or operates abnormally, use the wrench included in the
package to reset the system back to its original status. The procedure is as follows:
Step 1: Insert the wrench into the hole to press down on the reset button, which is located about
1.5 cm inside the surface of the casing.
Step 2: While keeping the reset button pressed, restart the system by powering off and on.
Step 3: The system will perform POST twice rather than the once. You can verify this by
observing the flashing “CONNECT” and “SERIAL” LEDs.
Step 4: After the system flashes the LEDs for the second time, withdraw the wrench to release the
button. The system will now be restored to the factory default settings.
12 VDC Power Adaptor
Connect the power jack of the included power adaptor. Connecting the power adaptor should be
the last step involved in the Video Server hardware installation.