Filter
Top Products
30
X
A No Memory Card
If the camera is turned off with a charged EN-EL15 battery and no
memory card inserted, S will be displayed in the control panel
and viewfinder.
A Using Two Memory Cards
Slot 1 is for the main card; the card in slot 2 plays a backup or
secondary role. If the default setting of Overflow is selected for Role
played by card in Slot 2 (0 96) when two memory cards are
inserted, the card in slot 2 will only be used when the card in slot 1 is
full.
Slot 1
Slot 2
The control panel shows the slot or slots that currently hold a
memory card (the example at right shows the icons displayed when a
card is inserted in each slot).
If the memory card is full or locked or an
error has occurred, the icon for the affected card will flash (0 324).
Control panel
Information display
D Memory Cards
• Memory cards may be hot after use.
Observe due caution when removing memory cards
from the camera.
• Turn the power off before inserting or removing memory cards.
Do not remove memory
cards from the camera, turn the camera off, or remove or disconnect the power source
during formatting or while data are being recorded, deleted, or copied to a computer.
Failure to observe these precautions could result in loss of data or in damage to the
camera or card.
• Do not touch the card terminals with your fingers or metal objects.
• Do not bend, drop, or subject to strong physical shocks.
• Do not apply force to the card casing.
Failure to observe this precaution could damage
the card.
• Do not expose to water, heat, high levels of humidity, or direct sunlight.
• Do not format memory cards in a computer.