Filter
Top Products
53
Device Registration: D1-Series Cameras
Windows Millennium Edition (Me)
Before You Begin
Confi rm that the OHCI-compliant IEEE 1394 interface board has been cor rect ly reg is tered
with the system.
Click the My Computer icon on the desk-
top with the right mouse but ton and select
Prop er ties from the menu that appears. The
Sys tem Prop er ties dialog will be dis played; click
the De vice Man ag er tab.
If “1394 Bus Controller” is not listed in the Device Manager, or if your IEEE 1394 interface
board or card is listed as an unknown or miscellaneous device or is pre ced ed by red or yellow
warning icons, follow the in struc tions in the manual pro vid ed with the board to ensure that
the drivers are properly installed.
After installing Nikon Capture 4 and restarting the computer, connect your camera to the
com put er using an IEEE 1394 cable and turn on the camera. The camera will be registered
automatically.
Follow the instructions below to check that the camera has been correctly registered with the
system.
Step 1
Once registration is complete, check that the
D1X (or D1 or D1H) has been cor rect ly reg is -
tered with the system. Click the
My Com put er
icon on the desktop with the right mouse but-
ton and select Properties
from the menu that
ap pears. The System Prop er ties di a log will be
dis played; click the De vice Man ag er tab.
Before Connecting the Camera
Be sure to install Nikon Capture 4 before connecting your camera to the computer.
Updating the Drivers for the D1
If you are already using the D1 with Nikon View DX or Nikon Capture, you will need to update the camera
drivers as described in “Updating the Drivers for the D1”
(
57).
The bus controller for your
IEEE 1394 board or card
should be list ed un der “1394
Bus Con trol ler.”