Filter
Top Products
60
Windows
Windows 98 Second Edition (SE)
Before You Begin
Confi rm that your OHCI-compliant IEEE 1394 interface board or card has been correctly reg-
is tered with the system.
Click the My Computer icon on the desk-
top with the right mouse but ton and se lect
Prop er ties from the menu that ap pears. The
Sys tem Prop er ties dialog will be displayed; click
the De vice Manager tab.
If “1394 Bus Controller” is not listed in the Device Manager, or if your IEEE 1394 in ter face
board or card is listed as an unknown or miscellaneous device or is preceded by a red or yellow
warning icon, follow the in struc tions in the manual provided with the board to ensure that
the drivers are properly installed.
After installing Nikon Capture 4 and restarting the computer, connect your camera to the
com put er using an IEEE 1394 cable and turn on the camera. The camera is registered au to -
mat i cal ly.
Follow the instructions below to check that the camera has been correctly registered with the
system.
Step 1
Once registration is complete, check that the
D1X
(or D1 or
D1H
) has been cor rect ly reg is tered
with the sys tem. Click the
My Com put er icon
on the desktop with the right mouse but ton
and select Prop er ties
from the menu that
ap pears. The System Prop er ties dialog will be
dis played; click the De vice Man ag er tab.
Updating the Drivers for the D1
If you are already using the D1 with Nikon View DX or an earlier version of Nikon Capture, you will need
to update the camera drivers as described in “Updating the Drivers for the D1” (
65).
Before Connecting the Camera
Be sure to install Nikon Capture 4 before connecting your camera to the computer.
The bus controller for your
IEEE 1394 board or card
should be list ed un der “1394
Bus Con trol ler.”