Filter
Top Products
15
EN
Preparations for shooting
Basic guide
Shooting
Shutter button
Card access
lamp
• The shutter sounds and the picture is taken.
• The card access lamp blinks and the camera starts recording the picture.
AF confirmation mark
Aperture
value
Shutter speed
1 Place the AF target on the
subject while viewing
through the viewfinder
2 Adjust the focus
3 Release the shutter
Press the shutter
button halfway.
Viewfinder
Control panel
Press the shutter button all
the way (fully).
Never remove the battery or card while the card access lamp is blinking. Doing so could
destroy stored pictures and prevent storage of pictures you have just taken.
• The focus is locked when a beep tone is output. The AF confirmation mark and the AF
target in focus light up in the viewfinder.
• The shutter speed and aperture value that have been set automatically by the camera are
displayed.
• The super control panel is not displayed while the shutter button is pressed.
Viewfinder
AF target
s0033_e_00_0_unified.book 15 ページ ２０１０年１１月１６日 火曜日 午後５時２４分