Filter
Top Products
41
EN
2
Exposure
2 Exposure
The camera sets the optimum aperture value and shutter speed automatically according to
the subject brightness.
While holding down the MODE button, turn the
main dial to set the shooting mode to P.
• When the shutter button is half-pressed, the shutter
speed and aperture value are displayed on the viewfinder
and control panel.
Program shift (
%)
By turning the main dial (or sub dial) in the P mode, you
can change the combination of aperture and shutter speed
while maintaining the optimum exposure.
g“Program line diagram (P mode)” (P. 140)
• The program shift setting will not be canceled after
shooting. To cancel program shift setting, turn the main
dial (or sub dial) until % disappears from the viewfinder or control panel, or turn off the
power.
• Program shift is not available when you are using a flash.
The shutter speed and aperture value are blinking:
j
The optimum exposure cannot be obtained. For details, see “Exposure warning display” (
g
P. 141).
Program shooting
TIPS
MODE button
j
AF confirmation mark
Shooting mode
Shutter speed
Aperture value
Control panel
Viewfinder
Viewfinder
Program shift
s0033_e_00_0_unified.book 41 ページ ２０１０年１１月１６日 火曜日 午後５時２４分