Filter
Top Products
77
EN
5
Flash shooting
Setting display
To adjust the flash using only the dials:
j Assign the flash intensity control function to the main dial (or sub dial). g“DIAL
FUNCTION” (P. 104)
x Notes
• This does not work during manual flash.
• This does not work when the flash control mode on the electronic flash is set to MANUAL.
• If flash intensity is adjusted on the electronic flash, it will be combined with the camera’s flash
intensity setting.
• When [w+F] is set to [ON], the flash intensity value will be added to the exposure
compensation value. g“w+F” (P. 112)
The camera shoots multiple frames, changing the amount of light emitted by the flash for
each shot. The camera shoots 3 frames at a time with the following amount of light: optimum
light, light adjusted in the – direction, and light adjusted in the + direction.
• The compensation value will change according to the EV
step. g“EV STEP” (P. 111)
• In single-frame shooting, the amount of light emitted by
the flash changes every time the shutter button is
pressed.
• In sequential shooting, hold down the shutter button until
the selected number of frames are taken.
• Releasing the shutter button stops flash bracketing
shooting. When it stops, 0 blinks in the viewfinder
and on the control panel and 0 is displayed in green
on the super control panel.
Direct button w + k
Super control panel ip: [w]
Viewfinder Control panel
TIPS
Flash bracketing
Menu MENU[X][BRACKETING][FL BKT]
F button
k
w button
BRACKETING
SETBACK
AE BKT
WB BKT
ISO BKT
FL BKT
FL BKT
3F 0.7EV
3F 0.3EV
3F 1.0EV
OFF
s0033_e_00_0_unified.book 77 ページ ２０１０年１１月１６日 火曜日 午後５時２４分