Filter
Top Products
21
Jog/Shuttle (Search dial)
(1) Press the search dial so that it remains
pressed in
Check that the JOG lamp lights.
(2) Turn the search dial
The dial’s click-stops are released, and the card data is
played back at the speed (–1x to +1x) corresponding to
the speed at which the dial is turned.
When you stop turning the dial, a still picture is shown.
(3) To transfer the memory card recorder from the
jog mode to another mode, press the button
corresponding to the mode
Note:
The factory setting is that when you turn the search dial
the mode switches to either shuttle mode or jog mode.
Select KEY at setup menu No. 100 (SEARCH ENA), so
the memory card recorder will not transfer to the search
mode unless you press the search button.
Jog mode
(1) Press the search dial so that it is released from
the pressed-in position
The SHTL lamp lights and the shuttle mode is
established.
•Immediately after switching the memory card recorder
on, turn the search dial and leave it at the center
position.
(2) Press the SHTL/SLOW button and switch to
[SHTL] or [SLOW]
(3) Turn the search dial
When the SHTL lamp lights, the playback picture speed
changes from 0 up to ±32x, depending on the dial
position.
This speed can be switched to ±8x, ±16x, ±32x, ±60x or
±100x at setup menu No. 101 (SHTL MAX).
The dial has a click-stop at the center position where the
still picture mode is established.
(4) To transfer the memory card recorder from the
shuttle mode to another mode, press the STOP
button or another button
Notes:
•The playback audio is audible in the –10 to +10x speed
range from the audio monitor output.
•The playback audio heard in the search mode contains
noise.
•When playing a clip that spans a multiple number of P2
cards at a speed faster than ±1x, the sound heard
during play may break up now and then: this is normal
and not indicative of a malfunction.
•When playing back at the –10x speed, the playback
sound may break up: this is normal and not indicative of
a malfunction.
Shuttle mode/Slow mode
Locate the edit points.
Each time it is pressed, it is set alternatively to the SHTL/SLOW mode or the JOG mode, and the JOG, SHTL or SLOW lamp
lights.
When the power is turned on, the search dial will not operate unless it is first returned to the STILL position.