Panasonic AJ-Spd850p Camera Accessories User Manual


 
72
TURN POWER OFF
Displayed when trouble has occurred in reading data from the card or
writing data onto the card. To continue operation, turn the power off and
then back on.
E-30 stop
Error messages (continued)
Message
Error
Description
No.
Deck
operation
COMM ERROR
Displayed when the orders issued by the system control command have
not been followed even after 3 seconds have elapsed. To continue
operation, turn the power off and then back on.
E-37 stop
SYSTEM ERROR
Displayed when trouble has occurred in communication. To continue
operation, turn the power off and then back on.
E-38 stop
Error messages
Monitor display
No. Message
DescriptionPriority
high
low
Deck operation
If E- lights up in the monitor display, the contents are displayed when the DIAG-MENU is opened.
E-21 REC WARNING
Displayed when trouble has occurred in the video or audio during
recording. To continue operation, turn the power off and then back
on.
stop
E-26 CARD ERR xx
Displayed when a data error caused by a P2 card has occurred during
recording. It remains displayed even after recording has stopped until the
next operation is performed. No display appears when an error has
occurred during playback. (xx denotes the slot number where the error
occurred.) Replace the P2 card in the slot where the error occurred.
stop
E-25 IRREGULAR CLIP
Displayed when there is an irregular clip. Recording can be continued
even while this message is displayed, but the clip should be fixed if,
for example, it is necessary to regenerate the time code.
After fixing the clip, turn the power off and then back on before
proceeding with the next operation.
operation
continues
E-50 BATTERY EMPTY
Displayed when a drop in the voltage of the internal clock's backup
battery has been detected while the power is on.
Replace the internal battery.
operation
continues
E-61 DVD DRIVE ERROR
Displayed when trouble has occurred in the DVD drive unit connection or
control. When a DVD drive unit is not connected, set the DVD setting to
[DISABLE]. When a DVD drive unit is connected, refer to the operating
instructions of the DVD drive unit.
stop
E-10 FAN STOP
Displayed when the fan motor has stopped.
Check the fan motor for foreign matter or objects.
operation
continues
Note:
•“E-50 appears when the backup battery has no more charge. After consulting with your dealer, replace it with a new
battery (CR2032 or its equivalent). After replacing the battery, be absolutely sure to set the decks internal clock using
setup menu No. 069 (CLOCK SET).