Panasonic AJ-Spd850p Camera Accessories User Manual


 
29
<Selecting the USER CLIP NAME recording method>
From the menu bar, select [OPERATION] [DEVICE
SETUP] [META DATA] [USER CLIP NAME] item.
Either [TYPE1] or [TYPE2] can be selected as the USER
CLIP NAME recording method.
[TYPE1]
[TYPE2]
1 Concerning the COUNT value
The COUNT value is indicated as a 4-digit number.
When the clip metadata has been loaded and [TYPE2]
has been selected as the recording method, the COUNT
value is incremented by 1 each time a shot is taken and a
new clip is generated.
It can be reset by following the sequence of steps below.
From the menu bar, select [PROPERTY] [DEVICE]
[META DATA] and then the [USER CLIP NAME] item.
The window shown below now appears. Align the pointer
with [COUNT RESET] and press the SET button to reset
the COUNT value to 1.
Concerning the incrementing of the COUNT value
of USER CLIP NAME with clips exceeding 4 GB
When a P2 card with a memory capacity of 8 GB or
more is used in this unit, if a one-time continuous
recording exceeds the prescribed duration (refer to the
section on Dividing clips over 4 GB in length on page
9) or if a one-time recording extends over more than one
card, the recording concerned will automatically be
undertaken as a separate clip. At this time, the COUNT
value is automatically incremented by 1 and recorded.
Example of recording (DVCPRO50) a clip on one
P2 card:
Example of recording a clip on two P2 cards:
If the clip thumbnails are shown and their properties are
displayed using a P2 series product, the thumbnail and
COUNT value of clip 1 will be displayed.
<Clear the uploaded metadata>
Select [OPERATION] [DEVICE SETUP] [META
DATA] [INITIALIZE] from the menu bar, and press the
SET button. Select YES when the confirmation screen
is displayed.
Clip 1/
COUNT value = A
Clip 2/
COUNT value = A + 1
REC start
(recording start)
Stop
(recording stop)
1st card 2nd card
Clip 1/
COUNT value = A
Clip 2/
COUNT value = A + 1
REC start
(recording start)
Recording duration = Approx. 15 min.
Approx. 10 min. Approx. 5 min.
Stop
(recording stop)
Working with clip thumbnails (continued)
When clip metadata has
been loaded
When clip metadata has
not been loaded or a
setting for not recording
the loaded clip metadata
has been selected
USER CLIP NAME to be
recorded
Uploaded data
Same as GLOBAL
CLIP ID (UMID data)
When clip metadata has
been loaded
When clip metadata has
not been loaded or a
setting for not recording
the loaded clip metadata
has been selected
USER CLIP NAME to be
recorded
Uploaded data
+ COUNT value
1
Same as CLIP NAME