Filter
Top Products
30
Clip number
Thumbnail
Clip information
Various indicators added to the clip, and the number
of added voice memos are displayed. If the P2 card
containing the clip is write-protected, a mark is
also displayed in this area.
Slot number
Working with clip thumbnails (continued)
Example: IP 192.168.000.002
MASK 255.255.255.000
GATE 192.168.000.xxx
“xxx” must be a value which does not exist on the
network connected.
DVD settings (optional)
Set whether to use the DVD drive. When not using the
DVD drive unit, use the initial setting [DISABLE]. Refer to
the operating instructions of the DVD drive unit when
using the DVD drive unit.
Note:
[EXPORT], which is used to save all the clips together in
the DVD, cannot be used when a P2 card with a memory
capacity of 8 GB or more is used.
Displaying the properties
This displays the clip properties, P2 card statuses and
device properties.
Displaying the clip properties
From the menu bar, select [PROPERTY], then [CLIP
PROPERTY] (alternatively, press the GO TO button
while holding down the SHIFT button).
The following screen is displayed.
Network settings
Perform the network settings.
(1) Press the THUMBNAIL button.
The thumbnail screen is displayed on the LCD.
(2)
Press the MENU BAR button, and select the
following from the menu bar: [OPERATION]
→[DEVICE SETUP] → [NETWORK] →[MANUAL].
Then select [IP ADDRESS] →[DHCP ON]/[DHCP
OFF].
If [DHCP OFF] is selected, set IP ADDRESS,
SUBNETMASK and DEFAULT GATEWAY.
(3) Next set [LOCALHOST NAME] and [USER].
(4) Set whether [FTP] is to be used and [SAMBA].
Enter the settings using the search dial and SET button.
Shown below is the device setup configuration.
Notes:
•Data cannot be recorded on the P2 card via the
network.
•As a setting for [LOCALHOST NAME] or [USER NAME],
a letter of the alphabet must always be used as the first
character.
For [LOCALHOST NAME]:
Alphanumerics and “-” can be used for the second and
subsequent characters.
For [USER NAME]:
Alphanumerics, “-” and “.” can be used for the second
and subsequent characters.
•The IP address of [DEFAULT GATEWAY] must be set
without fail even when there is no gateway.
Be absolutely sure to select a value which can be set
from the unit's [IP ADDRESS] and [SUBNET MASK].
[OPERATION]
[DEVICE SETUP]
[NETWORK]
[MANUAL]
[IP ADDRESS]
[DVD] [EXIT]
[LOCALHOST NAME]
[USER]
[NEW USER]
[HOST NAME]
[DELETE USER]
[CHANGE PASSWORD]
[SMB]
[WORK GROUP]
[EXIT]
[EXIT]
[FTP]
[SAMBA]
[EXIT]
[DHCP ON]
[DHCP OFF] [IP ADDRESS] / ···
[USER NAME] / ···
[USER NAME] / ···
[META DATA]