Filter
Top Products
215
10. Recording Motion Pictures
Applicable modes:
1
Start recording by pressing the motion
picture button.
A Elapsed recording time
B Available recording time
• Recording of motion picture appropriate for each mode is
possible.
• The recording state indicator (red) C will flash while
recording motion pictures.
• If approximately 1 minute elapses without an operation
being performed, part of the display will disappear.
Press [DISP.] to make the display reappear. This
operation is to prevent screen burn-in and is not a
malfunction.
• When recording a motion picture, do not cover the
microphone with your fingers or other objects.
• Release the motion picture button right after you press it.
2
Stop the recording by pressing the motion picture button again.
• Still picture recording is also possible during the motion picture recording by fully
pressing the shutter button. (P219)
Recording Motion Picture
About the operation sound that is produced when you stop recording
Since motion picture recording stops only after you press the motion picture button, the
sound of the operation may be noticeable. If the sound bothers you, try the following:
– Divide the last part of the motion picture using [Video Divide] (P239) in the [Playback]
menu.
The motion picture may not be divided near the very end of it. To avoid this, record
approximately 3 seconds longer.
– Set the camera to Creative Video Mode, and use a shutter remote control (optional) to
record motion pictures. (P321)
3
s
3
s
3
s
R
1
m
3737
sR
1
m
37
s
B
A
C