Filter
Top Products
Others
Q&A Troubleshooting
VQT5B76
- 213 -
Recording
Cannot record pictures.
●
Built-in memory/card is full.
→ Free space by deleting unwanted pictures (→55).
●
You may not be able to record for a short while after turning this unit on when using a large capacity
card.
Recorded pictures look white.
●
Lens is dirty (fingerprints, etc.).
→ Turn the camera off, retract the lens barrel and gently wipe the lens surface with a soft dry cloth.
●
Lens is foggy (→7).
Recorded pictures are too bright/too dark.
→ Adjust the exposure (→82).
●
[Min. Shtr Speed] is set to fast speed. Check the setting (→149).
Some pictures are taken when I press the shutter button just once.
●
Camera is set to use [WB Adjust.], [Auto Bracket] or [Burst].
●
Is the Self-Timer (→86) set to [10s / 3pictures]?
Focus not aligned correctly.
●
Not set to mode appropriate for distance to subject. (Focus range varies according to recording
mode.)
●
Subject outside of focus range. (→101)
●
Caused by jitter or subject movement. (→28)
Recorded pictures are blurred. The stabilizer function ineffective.
●
Shutter speed is slower in dark locations and the stabilizer function is less effective.
→ Hold camera firmly with both hands, keeping arms close to body.
●
When taking pictures at a slow shutter speed, use a tripod and a self-timer (→86).
●
When you record pictures using the zoom, jitter often occurs. Record pictures using the following
methods to reduce jitter.
→ Use a tripod and self-timer to record pictures.
→ Hold the unit in a stable position and use a viewfinder to record pictures.
→ Increase ISO Sensitivity or use [Shutter-Priority] Mode to record pictures with a faster shutter
speed.
Cannot use [Auto Bracket].
●
Only enough memory for 2 pictures or fewer.
Recorded pictures appear coarse, or there is interference.
●
ISO Sensitivity is high, or shutter speed is low.
(Default [Sensitivity] setting is [AUTO] – interference may appear with indoor pictures.)
→ Lower Sensitivity (→88).
→ Increase the setting for [Noise Reduction] in [Photo Style] or lower the setting for each of the
items other than [Noise Reduction] (→142).
→ Take pictures in brighter locations.
●
Has [High Sens.] in the Scene Mode been set? If so, the resolution of the recorded picture
decreases slightly because of high sensitivity processing, but this is not a malfunction.
Striping or flicker may appear under lighting such as fluorescent lighting
and LED lighting fixture.
●
This is characteristic of MOS sensors which serve as the camera’s pickup sensors.
This is not a malfunction.