Filter
Top Products
VQT2S30
66
Advanced (Recording pictures)
∫ Set the position of the histogram
•
Set the [HISTOGRAM] in the [CUSTOM] menu to [ON]. (P136)
Touch the histogram and drag it to the position you want to
move it to (P15).
•
You can also set the position of the histogram with 3/4/2/1 in the
Quick Menu (P34) while in button operation or [CUSTOM] menu.
Note
•
When the recorded picture and the histogram do not match each other under the
following conditions, the histogram is displayed in orange.
– When the Manual Exposure Assistance is other than [n0EV] during Exposure Compensation
or in the Manual Exposure Mode
– When the flash is activated
– When the flash is closed
• When the brightness of the screen is not correctly displayed in dark places
• When the exposure is not adequately adjusted
• The histogram is an approximation in the Recording Mode.
• The histogram displayed in this camera does not match histograms displayed by picture editing
software used in PCs etc.
• Histogram is displayed in R (red), G (green), B (blue), and Y (luminance) during the playback.
[REC] Mode:
Taking Pictures using the Built-in Flash
A To open the flash
Slide the flash open lever.
B To close the flash
Press the flash until it clicks.
•
Be sure to close the flash when not in use.
• The flash setting is fixed to [Œ] while the flash is
closed.
Note
•
Be careful not to catch a finger when closing a flash bulb.
Applicable modes:
Set the built-in flash to match the recording.
•
Open the flash.
Select [FLASH] in the [REC] Mode menu. (P32)
Switching to the appropriate flash setting
DMC-G2KPP-VQT2S30_eng.book 66 ページ ２０１０年４月１３日 火曜日 午後９時２０分