Filter
Top Products
13
Before Using
Re-attaching the Lens Cap
To protect the Lens surface, attach the Lens Cap.
• The Lens Cap and Lens Cap Cord come
preattached to the Grip Belt.
1 Pass one end of the Lens Cap Cord through
the attached eye on the Lens Cap. Then
pass the Lens Cap through the loop made
by itself and pull tight.
To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your
hand.
1 Detach the end of the Grip Belt.
2 Adjust the length of the Grip Belt to the size
of your hand.
3 Reattach the Grip Belt.
• When not using the Lens Cap, pull the Lens Cap
Cord in the direction of the arrow.
1
• When you are not recording, be sure to cover the
Lens with the Lens Cap for protection.
2
2
1
• When you remove the Lens Cap, press the knobs
firmly.
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap
before going out to avoid dropping the Camcorder.
1 Pull the end of the Shoulder Strap
through the Shoulder Strap Holder on the
Camcorder.
2 Fold the end of the Shoulder Strap, run
it through the Shoulder Strap Length
Adjuster, and pull it.
• Pull it out more than 1 inch (2 cm)
1
from the
Shoulder Strap Length Adjuster so that it cannot
slip off.
• Attach the other end of the Shoulder Strap to the
other Shoulder Strap Holder in the same way.
1
Inserting a Cassette
• Please use Genuine Panasonic DVC Tapes for more
information please contact your local dealer or visit
www.panasonic.com.
• For your reference if you travel frequently you should
also purchase a Panasonic head cleaning tape
AY-DVMCLA and use when HEAD CLOG message
appears on the LCD/EVF of your Camcorder.
1 Slide the [OPEN/EJECT] Lever
25
toward
the front and pull down to fully open the
Cassette Compartment Cover.
• To protect the tape, if the cover is not fully
opened, the cassette holder cannot be ejected.
25