Filter
Top Products
14
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Using
2 After the Cassette Holder is opened, insert
a Cassette.
3 Close the Cassette Holder by pressing the
[PUSH] mark
1
.
4 Only after the Cassette Holder is completely
housed, close the Cassette Compartment
Cover by pressing the mark
2
.
1
2
• When inserting a cassette, orient it as shown in
the above, and then securely insert it as far as it
goes.
When the Cassette Holder does not
come out
• Close the Cassette Compartment Cover
completely, and then open it again completely.
• Check if the battery has run down.
• Check if the Cassette Compartment Cover is in
contact with grip belt as shown below. If so, be
sure the grip belt stays clear of the cover when
opening.
When the Cassette Holder cannot be
housed
• Set the [OFF/ON] Switch
26
to [OFF], then to
[ON] again.
• Check if the battery has run down.
1 Open the LCD Monitor and then slide the
[◄OPEN] Lever
6
to open the Card Slot
Cover
7
.
2 While holding the Memory Card with its cut
corner facing right
1
, insert it into the Card
Slot
8
.
1
Inserting a Card
6
7
8
3 Close the Card Slot Cover
7
securely.
Removing the Card
Open the Card Slot Cover and press the center of
the Card and then pull it straight out.
• After removing the Card, close the Card Slot
Cover.
• The Camcorder may be damaged if the Card is
forced out when the Card is fully inserted.
Using a Memory Card (Optional)
A Card can be used to record still pictures.
• Use a genuine SD Memory Card or MultiMediaCard
manufactured by Panasonic only.
Before inserting or removing a Card, be sure to
turn off the Camcorder.
• Otherwise, the Camcorder may not function properly
or it may cause the loss of recorded data in a Card.
Accidental Erasure Prevention
• For other notes concerning this item, see page 50.
1
Opening the accidental erasure prevention slider
1
on the cassette (by sliding it to the [SAVE] arrow
direction) prevents recording. To enable recording,
close the accidental erasure prevention slider (by
sliding it to the [REC] arrow direction).